Troubleshooting - Polaroid XS100 Manual Del Usuario

POLAROID XS100 USER GUIDE
system.
2. Select the Helmet Mount with a suitable length of strap.
3. Loosen and detach the ball joint nut from the Helmet Mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Helmet Mount Socket, and you should hear a loud
click, then tighten the Ball Joint Nut.
5. Adhere the double-sided adhesive mount to the base of the Helmet Mount and fitting piece.
6. Attach the Helmet Mount at one side of the helmet.
7 . Loop the strap to the other side of the helmet, through the vent of fitting piece, and back to the original side of the
helmet.
8. Fasten the strap with a Strap Clip.
9. Repeat on the opposite end of the strap until the Helmet Mount is firmly attached to the helmet.
10. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the Mount-Lock Ball Joint Nut is
tightened securely.
11. The ball joint system allows you to change the angle of the camera. Simply loosen the nut, adjust the camera angle
and re-tighten the nut.
Tips for Achieving a Secure Mounting
• When straps are not practical, the 3M® adhesive pads can be used to attach the mount to smooth surfaces like
a motorcycle helmet. And don't worry about the adhesive ruining the helmet; they're removed quite easily when
heat is applied (eg. a hairdryer).
• For best results, maximum adhesion of the adhesive pad is achieved by first cleaning the helmet surface
thoroughly where the pad will be attached. Apply the pad firmly and allow it to remain unused overnight. The dry
time allows the adhesive to create a stronger bond.
• For ultimate camera support, use the straps and the 3M® adhesive pads.
Mounting on a Handlebar or Pole (.75 to 1.4-inch diameter)
1. Loosen both bike mount screws.
2. Attach the bike mount to the handlebar or pole and tighten the screws until the mount is firmly secured.
3. Loosen and detach the ball joint nut from the bike mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Bike Mount Socket, and you should hear a loud
click, then tighten the Ball Joint Nut.
5. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the Mount-Lock Ball Joint Nut is
tightened securely.
All manuals and user guides at all-guides.com
18
6. The ball joint system allows you to change the angle of the camera. Simply loosen the nut, adjust the camera angle
and re-tighten the nut.

Troubleshooting

PROBLEMS
1 LED flashes and
camera turns off
2 Cannot turn on the
camera
Red LED flashes
during recording
Cannot take photos or
video (Green LED
flashes
Cannot take photos or
video Green and Red
LED flashes
Cannot find
removable disk after
connecting the
camera to the
computer
POLAROID XS100 USER GUIDE
CAUSES SOLUTIONS
Battery is Recharge the battery
exhausted
Low battery Recharge the battery
Memory is full Replace memory
card with a new one
1 MicroSD card is 1 Insert MicroSD card
not inserted 2 Format the card
2 Card is not formatted
Connection Failure 1 Make sure cable
connections are
secure and restart
the computer if
necessary.
2 Try a different USB
port on the computer
19