3. TRANSPORT, PACKAGING AND STORAGE
3.1 Inspection after transport
Verification of the absence of damage and the integrity of the device must be carried out upon receipt of the
package. In the event of identification of damage due to transport, refuse or accept the product delivered only
under reserve *. A complaint detailing the defects observed must then be made. The perception of damages
is only possible in the event of a complaint formulated within the time limits provided, ie 24-48 hours at the
most.
* written on the right paper or digital delivery from the carrier.
3.2 Packaging
The packaging of the device must be kept in the event of a move, or for a return to the after-sales service.
The interior and exterior packaging must be completely removed before using the device. The standards in
force in your country concerning the protection of the environment must be respected before destroying the
packaging.
3.3. Storage
WARNING
The storage of the device in stock can be done but only in its original closed packaging.
Storage can be carried out under these conditions:
• Storage in a dry, non-humid place
• Sheltered from the sun
• Control of stock for more than 2 months (general condition of the device and all the elements that make it
up)
• No material shaking
• Storage in a closed room and not outside.
4. MATERIAL CHARACTERISTICS
* Subject to change
Model
Temperature
Supply voltage
Dimensions (mm)
Weight
Accessories
Digital temperature controller:
- The regulator is located at the back of the device
- There are two keys to lower or raise the temperature
- The first liquid crystal indicator corresponds to the compressor, lit when the compressor
is on for cooling
- The second liquid crystal indicator corresponds to defrosting, lit when defrosting
automatic is on
- This key corresponds to the LED lighting
CVRE120L
2-12°C
220V/50Hz
W 702 x D 568 x H 686
57kg
2 grid shelves
CVRE160L
2-12°C
220V/50Hz
W 880 x D 568 x H
W 1227 x D 568 x H 686
686
66kg
2 grid shelves
CVRE200L
2-12°C
220V/50Hz
94.5kg
2 grid shelves
EN