Bellman & Symfon BE1470 Manual Del Usuario página 56

Deleting the advanced programming
Follow the procedure below to delete the advanced programming:
1 Hold down the function button on the pager until the green and yellow Visit LEDs blink alternately.
Release the button.
2 Press the function button on the pager 3 times in quick succession.
3 All Visit LEDs will light up for ~2 seconds to show that it has been deleted.
107 Installer's guide
Troubleshooting
Most problems with the pager can be solved quickly by following the advice below.
If Try this
The pager seems
 The battery is depleted. Replace it with a 1.5V AAA alkaline battery.
to be turned off
Important! If you have a pager charger, only use a rechargeable 1.2 V
AAA NiMh battery in the pager.
The battery LED blinks
 The battery level is low. Replace it with a 1.5V AAA alkaline battery.
in yellow
Important! If you have a pager charger, only use a rechargeable 1.2 V
AAA NiMh battery in the pager.
The pager does not respond
 Check the batteries in the transmitters.
when a transmitter is
 Move the pager closer to the transmitter to make sure it's within radio range.
activated
 Check that the pager is set to the same radio key as the other units in the
Visit system, see Changing the radio key.
The pager is activated for
 There is probably another Visit system installed nearby that triggers your
no apparent reason
system. Change the radio key on all units, see Changing the radio key.
Installer's guide 108