Uline S-24125 Instrucciones

S-24125
HARD HATS
• Lightweight, low-profile fit.
• Made from ABS and Polycarbonate.
• Offers impact and penetration resistance,
dielectric up to 20,000 volts.
• Meets ANSI/ISEA Z89.1-14.
• Type 1 - Class C, E, G.
REFLECTIVE DECAL APPLICATION INSTRUCTIONS
1. Make sure helmet is clean from any dirt or debris.
2. Remove decal from backer sheet.
3. Apply decal to proper place on helmet.
(See Figure 1)
Figure 1
4. Press to make sure no wrinkles are in the decal.
REMOVAL OF DECALS
To remove, peel off and clean any residue with soapy
water.
CLEANING
Clean only with mild soap and lukewarm water. DO
NOT use paints, chemicals, adhesives, gasoline or
similar substances on the helmet. If these substances
are applied on the helmet, its impact resistance and
other features could be decreased, which could be
dangerous for the user. Store this protective helmet in a
clean, dry place that is out of direct sunlight.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
WARNING!
• This helmet is designed to protect against impacts
on the top of the shell. It is not designed to protect
against front, side or rear impacts.
• Never alter or modify the shell or suspension system.
Always use original replacement parts.
• Inspect helmet shell and suspension on a regular
basis. Check for cracks or faulty parts each time
it is to be used. If any sign of wear or rupture, the
faulty part should be discarded and immediately
replaced. The expected useful life of this
headwear is 5 years from date of manufacture. It
is recommended that the user replace this helmet
after that period of time.
• If the helmet has received a considerable strike, it
should be destroyed and replaced immediately,
even if there is no visible damage.
• This headwear has been tested and shown to be
resistant to the effects of environmental agents
normally encountered by headwear such as
perspiration, toiletries, cleaning agents and rain.
• Tighten the headband so that the safety hat does
not slip off while bending or nodding your head.
Ratchet suspensions are loosened or tightened by
turning the triangle-shaped knob on the back of
the suspension.
• Accessories such as winter liners or chin straps have
not been tested to the requirement of this standard.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0121 IS-24125