KlipXtreme NITRO KBS-025 Manual página 4

1. On/Off - Bluetooth mode indicator: Press and hold this button to turn the
®
speaker on or off, or to connect it to the Bluetooth
after approximately ten minutes of inactivity if it is not connected to the Bluetooth
device. An audible tone will indicate when the speaker has paired with your smart
device or when it has been disconnected.
Built-in microphone: Use it for hands-free calling and conferencing.
2. Mode LED indicator:
• In Bluetooth mode, the LED light blinks in blue to indicate that the device has
®
entered into the pairing mode and is ready to be detectable for the first time.
• The LED light glows solid blue to indicate that the device is successfully paired.
• The LED light blinks slowly in blue while streaming music in Bluetooth
• The LED light will remain solid blue when the speaker is in working mode (even
when it is not playing audio).
3. Volume –/Previous track button: Press and hold this button to decrease the
volume level of the speaker. Press it briefly to play the previous track.
4. Play/Pause - Multifunction button:
• Playback mode: Press this button to play or pause your music. If the speaker was
playing music before receiving a call, it will automatically resume playback after the
call has ended.
• Hands free mode: Press the Play/Pause button to answer and end a call.
Press and hold if you wish to reject an incoming call.
Press the Play button twice to redial the last number called (on supported
devices).
All manuals and user guides at all-guides.com
mode. The unit will shut off
®
®
mode.
®
5. Volume +/Next track button: Press and hold this button to increase the volume
level of the speaker. Press it briefly to play the next track.
7. Charging LED indicator
Status
Battery fully charged
Battery is charging
8. DC 5V Micro-USB charging port: Charges the built-in battery of the speaker.
9. Micro-USB charging port rubber cover: WARNING: In order to protect the
speaker from water damage this rubber cover must be kept closed at all times.
III. Charging the speaker
• Plug one end of the supplied Micro USB cable into the speaker Micro USB port
and the other end to the USB port of your computer, laptop or AC adapter to
charge the battery.
• Make sure that your portable speaker is fully charged before using it for the first
time.
• The battery will take about 3 to 4 hours to fully charge.
• While charging, the LED is solid red. When the battery has reached full capacity,
the LED light will turn off.
Led indication
The LED indicator turns o
The red LED indicator lights up