Product Operation - GINGKO Cube Plus Manual De Usuario Rápido

Product Operation

Product ON/OFF: Long touch the power button
Time Setting
1. Long touch the HR or MIN button for 5 seconds until a beep to access
time setting mode. Both hours and minutes number will start flashing.
2. Short touch on HR or MIN buttons to adjust the hours or minutes, the
number can be scroll up faster if you leave your finger on the button. Please
note you can only scroll up and not down.
3. After the right hours and minutes have been selected, short touch on the
button to confirm and exit the time setting.
Alarm Time and Alarm Sound Setting
1. Short touch the button will show the current alarm. Long touch
to go to alarm setting mode and the numbers will start flashing.
2. Use the HR or MIN button as instructed above to set hours and minutes.
3. Short touch again to confirm alarm and move onto alarm sound
setting.
4. Touch HR or MIN button to select your preferred alarm sound.
A1 - Rooster; A2 - Forest Birds; A3 - Sea Waves
5. Short touch to confirm and exit the setting.
Sound Activated or Permanent Display Setting
The LED display can be set on sound activated display or permanent display.
When in sound activated display, the LED display will automatically switch
off when the room is quiet and light up again when you touch, tap it, click
your fingers or clap your hands. The LED display will be on constantly if set
to permanent display.
T/S
1. Short touch button when clock is in time display mode, the clock will
display either —-: Sd or oN:Sd
- -: Sd - Permanent display
ON: Sd - Sound activated display
2. Select your preferred mode.