Additional Warnings; Technical Data - Stanley-Bostitch MB2140-E Especificación Técnica

POWER ADJUSTMENT (TU-216-2330-E / TU-216-1825-E)
For maximum power: rotate valve anticlockwise as far as possible. (Fig. 6)
To reduce power: rotate valve clockwise for up to 30% reduction. (Fig. 7)
TOOL OPERATION CHECK (TU-216-2330-E / TU-216-1825-E):
WARNING! Remove all fasteners from tool before performing tool operation check.
A. With finger off the trigger, hold the tool with a firm grip on the handle.
B. Place the nose of the tool against the work surface.
C. Raise the secondary trigger device.
D. Pull the trigger to cycle the tool. Release the trigger and cycle is complete.
WARNING! With the secondary trigger device raised, the tool will cycle each time the trigger is pulled!

ADDITIONAL WARNINGS:

WARNING (TU-216-2330-E / TU-216-1825-E)! The secondary trigger device should be checked periodically, to
ensure it is operating correctly.
While following the above tool operation check notes, release the secondary safety trigger and the operating trigger
simultaneously, this should automatically lockout the operating trigger, preventing the tool from being actuated.
The tool should only then operate again when the secondary trigger device is raised and the operating trigger is
depressed.
WARNING! If the tool fails to work correctly contact you local STANLEY service centre or distributor for advice
before continuing to use it.
WARNING (TU-216-2330-E / TU-216-1825-E)! Under no circumstances should the secondary trigger device or the
operating trigger be by-passed, modified or removed.
FASTENER JAM CLEARING:
WARNING! Always disconnect air supply before clearing a jammed fastener.
TO CLEAR A JAMMED FASTENER:
1. Release the magazine and pull it back to stop pin feeding.
2. Loosen the two screws as shown in (Fig. 8) by one full turn.
3. Slide cover down until the two large clearance holes line up with the two screw heads as shown in (Fig. 9).
4. Pull the cover away from nose as shown in (Fig. 10).
5. Remove the jammed fastener.
6. Re-install cover, slide it up, tighten the two screws and close magazine.
7. Reconnect air hose.
UTILITY HOOK (MB2140-E- Fig 11)
These tools include an additional utility hook suitable for storage and temporary hanging of the tool.
WARNING! Never use the utility hook to hang the tool from the body, clothing or belt.

TECHNICAL DATA:

Please look for the technical data in the table marked ? at the end of this manual.
A Length mm.
B Height mm.
C Width mm.
D Weight Kg.
E Noise L , 1s, d
PA
F Noise L , 1s, d
WA
G Noise L , 1s, 1m
PA
H Vibration m/s 2
I P max Bar
J P min Bar
All manuals and user guides at all-guides.com
K Air consumption per shot @ 5.6 Bar
L Activation type
M Summer lubricant
N Winter lubricant
O O-ring lubricant
P Fastener Name
Q Dimensions mm.
R Head/crown
S Magazine capacity
T New Driver Length mm.
U Max. Depth Inside Piston mm.