Max STORM 6 Manual Del Usuario página 8

USER'S GUIDE BUILT-IN NAIL DUST COLLECTOR
MAX STORM
General description
The MAX Storm nail dust collector is designed for use by professional
manicurists. It serves to remove dust, which appears in the process of nail filing
and to remove of artificial coatings.
Usage of the nail dust collector is recommended:
• during gel and acrylic nail extension, nail correction;
• while removing of gel polish and other artificial coatings;
• when performing manicure (especially hardware one).
Complete set
1. Dust collector with a filter bag installed.
2. Additional filter bag.
3. Passport.
Operational principles
The manicurist works in the dust collector fan grill area. The dust-air mixture is
sucked with the fan impeller of the dust collector. Clean air flows back into the
room after its filtration through the bag filter. Dust is collected inside the filter.
The manicurist cleans the filter bag after finishing.
Installation of the dust collector
In order to install the nail dust collector, make a hole in the tabletop in
accordance with the template (see Appendix 1).
1. Disconnect the air duct from the bottom of the dust collector.
2. Place the dust collector on the tabletop. Choose the direction in which it will
be installed. We recommend installing the dust collector with the wide side
of the hexagon towards the nail artist and the client. When installed in the
described manner, the switch will be on the side of the suction area.
3. Place the stencil plate on the tabletop. An additional cutout of the stencil
ENG
Dust collector layout.
1.
dust collector (top cover)
2.
3.
4.
8
Above-desk part of
On / Off button
Fan
Air duct