seconds.. To. go. back. to. normal. mode,. just. press. the.
'PWR' button again.
To. test. the. indication. of. each. signal,. you. press. the.
'CITY' and 'MUTE' key simultaneously. If you press
the.ON/OFF.key.(PWR),.you.go.back.to.Standby-mode.
This.action.makes.it.possible.to.undo.all.settings.and.to.
go.back.to.default.settings.
•
Keep the ON/OFF (PWR) and the 'MUTE' key
pressed.simultaneously.
•.. Turn.the.unit.on.by.connecting.the.cigar.lighter.plug.
•.. Wait.a.moment.until.you.hear..small.beeps.
•
Release the ON/OFF (PWR) and the 'MUTE' key.
MAINTENANCE
To.keep.your.detector.in.good.condition,.follow.these.
simple.steps:
•.. Never. leave. the. set. on. the. visor,. windshield. or.
dashboard.when.you.park.your.vehicle.
•.. Do.not.expose.the.unit.to.moisture.
•.. Always. unplug. the. power. cable. or. turn. off. the.
power.when.not.in.use..
If.your.unit.does.not.work,.we.advise.you.to.complete.
RESET
following.checks:
•.. Is.the.power.cord.properly.plugged.in.at.both.ends?
•.. Is.the.fuse.OK?
•.
Is.the.ON/OFF.key.(PWR).used.to.switch.the.unit.ON?
FUSE REPLACEMENT INSTRUCTIONS
•.. Press.the.top.of.the.fuse.holder.down.and.rotate.it.
anti-clockwise.approx..0°..Lift.the.top.straight.up.
•
Remove the fuse and replace if required by one of
the. same. rating..The. silver. tip. contains. a. spring,.
which may fly off when disassembling. The fuse
should.be.inserted.before.the.spring.
•.. Place.the.top.of.the.fuse-holder.back.on.the.body..
Press.down.and.rotate.the.top.of.the.fuse.holder.
clockwise.approx..0°.
NOTE :
•.. Failing. to. press. the. top. of. the. fuse. holder. down.
prior.to.rotating.it.will.damage.the.fuse.holder..Use.
of.pliers.to.rotate.the.top.may.also.cause.damage.
•.. Illustration. indicates. the. direction. that. the. fuse.
holder.top.must.be.rotated.to.reassemble.
.
-GB-9-