Uline H-6134 Manual Del Usuario página 2

INSTALL REPLACEMENT BATTERY
5. Place replacement battery into unit. (See Figure 5)
NOTE: Terminal posts must face back of unit.
Terminal
Post
6. Place one corner bracket against edge of battery.
Line up holes in bracket with holes in straddle stacker.
Use one 10 mm bolt and two spacers for each hole.
Loosely tighten with 10 mm wrench. (See Figure 6)
NOTE: Do not overtighten bolts.
Figure 6
Holes
7. Repeat step 6 to install other corner bracket. Once
both corner brackets are in place, completely
tighten 10 mm bolts to secure battery.
PAGE 2 OF 6
INSTALLATION CONTINUED
Figure 5
10 mm
Bolt
Corner
Bracket
Edge
Spacers
1-800-295-5510
uline.com
8. Remove wing nuts from terminal posts. Then, attach
cables to terminal posts and secure with wing nuts.
(See Figure 7)
NOTE: Place large cable over post first, then
small cable second.
Figure 7
Large
Cable
9. Replace cover using bolts and washers from step 1.
(See Figure 1)
Wing Nut
Small
Cable
0621 IH-6134