Makita MRP100 Manual De Instrucciones página 5

settings.
Do not lower the knob too low. The bit will protrude
•
dangerously.
Stopper block
1
2
3
004926
As the rotary stopper has three adjusting hex bolts, you
can easily obtain three different depths of cut without
readjusting the stopper pole. To adjust the hex bolts,
loosen the hex nuts on them and turn the hex bolts. After
obtaining the desired position, tighten the hex nuts to
secure the hex bolts.
Switch action
004927
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
Make sure that the shaft lock is released before the
•
switch is turned on.
To start the tool, move the switch lever to the I position.
To stop the tool, move the switch lever to the O position.
CAUTION:
Hold the tool firmly when turning off the tool, to
•
overcome the reaction.
1. Stopper pole
2. Chip deflector
3. Stopper
4. Adjusting hex
bolt
4
5. Hex nut
5
1. Switch lever
1
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the bit
3
004928
CAUTION:
Install the bit securely. Always use only the wrench
•
provided with the tool. A loose or overtightened bit
can be dangerous.
Do not tighten the collet nut without inserting a bit
•
or install small shank bits without using a collet
sleeve. Either can lead to breakage of the collet
cone.
Insert the bit all the way into the collet cone. Press the
shaft lock to keep the shaft stationary and use the
wrench to tighten the collet nut securely. When using
router bits with smaller shank diameter, first insert the
appropriate collet sleeve into the collet cone, then install
the bit as described above.
To remove the bit, follow the installation procedure in
reverse.
OPERATION
1
005112
CAUTION:
Before operation, always make sure that the tool
•
body automatically rises to the upper limit and the
bit does not protrude from the tool base when the
lock lever is loosened.
5
1. Shaft lock
2. Wrench
1
3. Bit
2
1. Chip deflector