EHEIM classic 4200130 Manual De Instrucciones página 13

English
‧ If they are not being used, always disconnect all devices in the aquarium from the power supply
before you install/remove any parts and before all cleaning and maintenance work.
‧ Protect the mains socket and mains plug against moisture and wetness. A drip loop
must be formed with the mains cable.
This prevents any water running along the cable to the mains socket, which would
result in a short-circuit.
‧ The electrical data of the appliance must match the data of the power mains. This
data is found on the type plate, the packaging and in these instructions.
‧ The distance from the underside of the light to the highest water mark must be a minimum of
15 mm.
Commissioning
Fitting the LED holder
1. Lay the mains cable ③ along under the LED light ① (⌦A).
2. Push the LED holder ② approx. 2 – 3 cm over the LED light edge.
3. Turn the LED holder by 90° in a clockwise direction (⌦B).
4. Press the LED holder downwards until the LED light engages (⌦C).
5. Adapt the length of the LED light to your cover frame by moving the LED holder accordingly (⌦D).
6. Fasten the cable in the LED holder with the snap fittings (⌦E).
7. Place the LED light in the cover frame ④. Make sure that the LED light is secure (⌦F).
8. Feed the cable into the cover frame and through the rear opening to the outside.
‧ For maintenance work, the LED light can be pushed into the cover frame (⌦F).
‧ The LED light can be directly placed on an open aquarium with the holder.
Operation
Switching the LED on/off
DANGER! Electric shock due to penetrating water!
The LED light is only protected against penetrating water if immersed temporarily.
▶ The distance from the underside of the LED light to the highest water mark must be a minimum of
15 mm (⌦G).
The power supply unit is not protected against penetrating water!
▶ Never mount the power supply unit on or in the cover frame.
1. Connect the plug ⑥ of the LED light to the socket of the power supply unit ⑤ (⌦H).
2. Tighten the plug with the union nut (⌦I).
3. Insert the mains plug in the mains socket.
Optional accessories (not included in the scope of delivery)
Adapter set T5/T8
(EHEIM item no.: 4200130)
With the T5/T8 adapter, you can replace traditional fluorescent bulbs with the EHEIM classicLED.
The T5/T8 adapter set is available as an original EHEIM accessory.
13