Important Warnings - Ortotecsa F.12 Manual De Usuario

The vertical position is produced in a linear manner and with minimal effort on the part of the
operator, with maximum comfort for the patient.

IMPORTANT WARNINGS!

When using a tilting table – standing frame the centre of gravity is always relatively high up. A
person using a tilting table/standing frame is always dependent on the stability of the device, from
the supporting points against the body and support area to the floor.
Our main objective was to developed a device, wich satisfies the demands of many medical
indications. Nevertheless, a tilting table/standing frame cannot be used without exception in all
situations. The application and utilization should always be followed through with sense and reason.
- The tilting table / standing frame may only be operated with continues presence of a qualified
person, respectively a family member of the use.
- It may only be used by persons of a suitable stature and physical aptitude.
- Never place a patient in a standing aid, wich is not coordinate with his or hers body weight and
height.
- Do not place any hot containers or objects on the therapy table, as hereby the wood or coating
could be seriously damaged.
- Do not place any heavy objects on the device (for example on the table) as it would affect the
centre of gravity and consequently impair the balance.
- Do not operate or take any action if unsure of its effects; if in doubt please contact the nearest
technical service centre or manufacturer.
- Always ensure there are no obstacles in operating range of the device, such as carpets, stairs or
objects on the floor, wich could lead to the device overturning.
- Never use the device on rough terrain, steeply sloping grounds or stairs.
- Never leave the user unattended with the device.
- Do not use without ensuring a correct mounting of thesafety belts.
- Never place the device on steep grades.
- Do not use the device if any parts are damaged or missing.
- In case of malfunction or accident contact the reseller from whom you pursached the deviced
from. Control before every use, that all adjustable parts are always locked.
- Check regulary if all screws and handles tec. are tightly fastened. Worn and defect parts are to be
repaired or replaced inmediatly. This is specially important to ensure a safe use of the aid. Carefully
check for a firm hold of the clamping jigs and the like.
- Adjust settings only in the unladed condition.
- Be careful when moving the device, whilst a patient is standing in the device. This is particulary
applicable when crossing ramps, thresholds and similar. Never allow person not familiar to operate
the standing aid respectively those who have not read this operating manual.