FONESTAR MSH-883 Manual De Usuario página 3

DOUBLE RECEIVER (models MSH-892, MSH-895 and MSH-898))
1.- STANDBY: on/off button for the receiver in standby mode.
2.- IR: infrared receiver.
3.- IR-SW: by pressing this button the receiver transmission channel is sent to the transmitter microphone.
Then, place both the IR receivers opposite each other. The transmitter as well as the receiver will be
tuned into the same frequency and the same channel number.
4.- SCAN: this lets you automatically select an interference free channel
5.- Information display.
6.- Channel number and transmission frequency indicator.
7.- Volume level indicator.
8.- Wireless microphone battery level indicator. The battery level is shown when the microphone has been
tuned into the same channel as the receiver.If the level is low, the display lights up red.
9.- Receiver lock indicator.
10.- Radiofrequecy signal level indicator.
11.- Audio signal level indicator.
12.- w: for selecting the following channel on the list.
13.- SET: manual mode channel selection. Press the button and then press the w/s buttons to choose the
desired channel. Once the channel has been selected, wait approximately 2 seconds until the option
stops blinking on the display and the channel will have been automatically selected. The channel can
also be locked by pressing this button after the channel selection option has been blinking.
14.- s: for selecting the previous channel on the list.
15.- VOLUME: controls for regulating the audio output volume.
16.- DC IN: DC power supply input. With 230 V AC/12.8 V DC adapter included.
17.- ANTENNA: female TNC aerial connector allowing the connection of the aerials supplied.
18.- BALANCED: balanced audio output, XLR connector.
19.- UNBALANCED: unbalanced audio output, 6.3 mm mono jack connector.
20.- MIX OUTPUT: mixed audio output for the 2 receivers, 6.3 mm mono jack connector.
- 3 -
EN