Uline H-9931 Manual página 4

TO UNBIND DRAIN SNAKE
1. Set the front handle to the unlocked position and
the forward/reverse switch to the reverse position.
2. Withdraw the tool a few inches while in reverse to
free the cable.
3. Stop the tool.
4. After the tool has come to a complete stop, switch
back to the forward position.
CAUTION! Running the tool in reverse for
extended periods can cause damage to the
cable and accessories.
WARNING! To reduce the risk of injury, always
unplug the charger and remove the battery
pack from the charger or tool before
performing any maintenance.
CAUTION! Never disassemble the tool, battery
pack or charger. Contact Uline Customer
Service at 1-800-295-5510 for all repairs.
MAINTAINING TOOL
Keep tool, battery pack and charger in good repair
by adopting a regular maintenance program. Inspect
tool for issues such as undue noise, misalignment or
binding of moving parts, breakage of parts or any
other condition that may affect the tool operation. If
the tool does not start or operate at full power with a
fully charged battery pack, clean the contacts on the
battery pack.
WARNING! To reduce the risk of personal injury
and damage, never immerse tool, battery
pack or charger in liquid or allow a liquid to
flow inside them.
PAGE 4 OF 22
OPERATION CONTINUED
REMOVING CABLE FROM DRAIN
1.
2. Pull the trigger slightly and pull the tool back to
3. Release the trigger.
4. Wipe the exposed cable with a rag and feed it
5. Repeat steps 2-4 until the cable is free from the
6. Before storing the tool, wash the cable and drum
MAINTENANCE
CLEANING
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild soap
and a damp cloth to clean, since certain cleaning
agents and solvents are harmful to plastics and other
insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household detergents
containing ammonia. Never use flammable or
combustible solvents around tools.
CLEANING CABLES, COVERS, DRUMS
AND BUCKETS
Cables, covers, drums and buckets should be
thoroughly flushed with water after every use to prevent
damaging effects of sediment and drain cleaning
compounds.
After washing, dry the cable, cover and drum
completely. Wipe cable with an oiled rag before
returning it to the drum. (See "Cable Installation"
on page 2.)
Set the front handle to the unlocked position and
the forward/reverse switch to the forward position.
remove about 12" of cable from the drain.
back into the tool.
drain.
(see "Cleaning Cables, Covers, Drums and Buckets"
in Maintenance).
WARNING! Always wear leather gloves over
latex/rubber gloves to avoid entanglement.
0122 IH-9931