Cleaning And Maintenance - cecotec BAMBA PRECISIONCARE WET&DRY Manual De Instrucciones

ENGLISH
Charging
Turn the clipper off before connecting it to the charger and the power supply.
During charge, the plug icon will turn on red and the battery percentage will be displayed
accordingly: 20-40-60-80-100.
When fully charged, it will display 100 in white.
The plug icon will flash in red when battery is low.
For a quick-charge, charge it 5 minutes and operate it for 3-5 minutes.
Lock
The clipper includes a safety lock system.
Press and hold the power button for 3 seconds to lock the device. The lock icon will turn on
white.
Press and hold the power button for 3 seconds to unlock the device. The lock icon will disappear
from the display.
The device will also be unlocked when connected to the charger.
How to adjust the cutting length
Blade-adjustment switch:
The cutting length can be adjusted through the blade-adjustment switch during operation or
before the appliance is switched on.
Slide the switch to the right for shorter haircuts, or slide it to the left for longer-length haircuts
(0.5 mm, 1 mm, 1.5 mm, 2 mm).
Clip-on guide comb:
Depending on the type of haircut, the clipper can be operated with or without the comb
attachment.
Place the attachment comb onto the cutting edge of the cutting set and press it down onto the
cutting set until it clicks into position.
To remove the guide comb, pull from the tabs on both sides of the attachment and slide the
comb out of the device.

4. CLEANING AND MAINTENANCE

Turn off and disconnect the device from the mains supply before cleaning, assembling or
disassembling any of its parts.
Do not use compressed air, abrasive scouring pads, powders or cleaners to clean the product.
The clipper is waterproof, therefore can be washed with water, but do not immerse the
appliance's body in water or any other liquid. Do not use hot water.
Clean the clipper and the attachments after each use.
24