Service And Adjustments - Tramontina 79949005 Manual De Uso Y Mantenimiento

EN
DRAWBAR OFFSET
The drawbar can be attached to the center, left hand or right hand side of the drawbar offset tube.
SWEEPING SPEED
Adjust the speed according to the conditions to achieve best results.
DUMPING OF SWEEPER
Your sweeper can be dumped without getting off of the rider or riding mower. Unclip dump lever from pivot rod
and pull forward to empty the hopper. Always empty hopper after each use.
Before storing your sweeper, always empty the bag to prevent spontaneous combustion.
1. Cleab the sweeper and hopper bag thoroughly to help prevent rust and mildew.
2. To collapse the hopper bag for storage, remove the two hopper support rods from the rear of the hopper.
3. Remove the hitch pin (20), [Fig. 02, page 05] from the center hole, fold the drawbar (8), [Fig. 02, page 05] to the
right or left and then replace hitch pin (20), [Fig. 02, page 05].
4. Store in a dry area.
BRUSH REPLACEMENT
Replace brushes one brush at a time.
1. Remove the hopper bag from the sweeper.
2. Loosen hex bolts and lock nuts on two single brush retainers which
clamp one brush to the double brush retainers. Do not loosen or remove
bolts which fasten double brush retainers to brush shaft [Fig. 26].
3. Slide the brush out of the retainers, noting on which side of the brush
the bristles overlap.
4. Install new brush, making sure the bristles overlap on the same side
of the brush as before.
WHEEL GEAR AND PAWL
Do not remove both wheels at the same time; parts are not interchangeable [Fig. 27, page 12].
• Remove hub cap (1), bolt (2), washer (3), wheel (4), step spacer (8), and nut (9).
• Remove snap ring (5), ratchet gear (6), and drive pin (7). Clean shaft and gear.
• Install ratchet gear (6) and drive pin (7). Pin must move freely in shaft.
• Lightly grease shaft and fill ratchet gear (6) with grease.
• Lightly grease brush axle and gear teeth on wheel.
• Install hub cap (1), bolt (2), washer (3), wheel (4), step spacer (8), and nut (9).
:
Note brushes should only move during forward rotation. If brushes rotate in both directions, drive pin is jamming
the ratchet gear. Disassemble and make sure drive pin moves freely.
17
HOW TO USE YOUR SWEEPER
STORAGE

SERVICE AND ADJUSTMENTS

26
OVERLAPPED BRISTLES