Cooling Down; Electrical Safety - Famastil F-POWER FST201-m Manual De Instrucciones

In use, the nozzle (5) of your heat gun becomes extremely hot. Great care is necessary
when cooling your heat gun after use.
This tool can also be used in stationary mode:
01 Place the tool onto a firm and stable
surface as shown (PIC 5).
02
Always point your heat gun away from
you.
03 Secure the cable to prevent pulling
your heat gun off the stand.
04 Do not touch the nozzle (5) and ensure
that nothing is dropped into the nozzle.
05 Carefully switch off your heat gun
and then allow it to cool.
Your heat gun is designed to soften paint and lacquer enabling it to be removed
using a good quality hand scraper. Proceed as follows:
Direct the hot air onto the area to be removed. When the paint softens, scrape firmly.
Experiment to establish the length of time necessary to apply the heat to obtain
optimum results. Scrape the softened paint immediately or it will harden again.
WARNING! Your heat gun is not suitable for stripping metal-framed windows.
This is because the heat from the heat gun is conducted through the metal
and can crack the glass. Scrape with the grain of the wood wherever possible.
Do not linger on one spot for too long as the surface may char or ignite.
This tool is double insulated; therefore no earth wire is required.
Always check that the power supply corresponds to the voltage on
the rating plate.
All manuals and user guides at all-guides.com

COOLING DOWN

HANDS FREE USE
PAINT STRIPPING

ELECTRICAL SAFETY

PIC 5
25