Set - Up And Use - VERTBAUDET 70323-00119 Manual De Utilización

 TO PROVIDE CONTINUED PROTECTION AGAINST RISK OF ELECTRIC
SHOCK, CONNECT TO PROPERLY GROUNDED OUTLETS ONLY.
 CAUTION: RISK OF ELECTRIC SHOCK, DISCONNECT ELECTRIC POWER
BEFORE SERVICING.
 NEVER USE ANY ADDITIVES.
 THIS APPLIANCE SHALL NOT BE USED BY CHILDREN. KEEP THE
APPLIANCE AND ITS CORD OUT OF REACH OF CHILDREN.
 APPLIANCE CAN BE USED BY PERSONS WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND
KNOWLEDGE IF THEY HAVE BEEN GIVEN SUPERVISION OR
INSTRUCTION CONCERNING USE OF THE APPLIANCE IN A SAFE WAY
AND UNDERSTAND THE HAZARDS INVOLVED.
 CHILDREN SHALL NOT PLAY WITH THE APPLIANCE.
 THE APPLIANCE MUST NOT BE IMMERSED.
 WARNING: AVOID SPILLAGE ON THE CONNECTOR.
 THERE IS A POTENTIAL RISK OF INJURIES FROM MISUSE.
 THE HEATING ELEMENT SURFACE IS SUBJECT TO RESIDUAL HEAT
AFTER USE.
 REGARDING THE INSTRUCTIONS FOR CLEANING OF THE APPLIANCE,
THANKS TO REFER TO THE BELOW PARAGRAPH OF THE MANUAL.
Set – up and use
Before placing items in the appliance for sterilization it is important that all
bottles, nipples and accessories are empty and that they are clean and fully
rinsed in fresh water.
1. Place the appliance on a flat surface where it is out of reach of children and
it will not be knocked or moved during operation.
2. Remove the lid, accessory steaming set from the sterilizer base.
3. Pour water on the stainless steel heater surface to MAX line (120ml). Never
fill past MAX line.
4. Place the accessory steaming set on the base.
5. Place clean bottles with their opening facing downward on the lower posts
of the accessory rack. Place the bottle accessories (e.g.nipple, collar,cap,etc)
on the upper posts of accessory steaming set