Danger Of Fire; Master/Slave-Operation - Futurelight CF-200 Manual Del Usuario

IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
and over the trussing system or a safe fixation spot. Insert the end in the quick link and tighten the safety
screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Master/Slave-operation

The master/slave-operation enables that two devices can be synchronized and controlled by one master-
device.
On the rear panel of the CF-200 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting the two devices.
Choose the device which is to control the effects. This device then works as master-device and controls the
slave-device, which is to be connected to the master-device via a balanced microphone lead. Connect the
DMX OUT-jack with the DMX IN-plug of the next device.
d 001
n n1n
Set the desired Master-mode for the master-device. Set the respective Slave-mode for the slave-device.

DANGER OF FIRE!

DANGER TO LIFE!
Control Board:
n n2n
DMX-mode
n
n3n
Master-mode:
Sound-control
Master-mode:
Slow
s s1s
Master-mode:
Standby
23/54
Slave-mode:
Slave 1
51837540X18NXS_V_1_1.DOC