CNA CONTROL AIR TH 600 DURALUM Manual De Instalación, Uso Y Mantenimiento página 9

Close the space that remains between the hood and the wall,
adjunsting the spacer (F).
Before completing any connection, make sure the house voltage
corresponds with the voltage indicate on the data label.
Accessible parts may heat up when using cooking appliances.
Air Intake Speed (Fig 2)
The front panel has to be pulled its maximum extension so as to
optimise the extraction capacity.
The three setting switch (C-2) has the following functions:
0 Stop
1 Low Speed
2 High Speed
Switch on the Lamps (C-1 Fig 2)
Pull out the grill (G) more than 50mm
SUCTION VERSION
If the hood is to be installed as a SUCTION hood, connect the plastic
outlet piece (A) supplied with the hood (120mm diameter pipe for
better performance and lower noise levels.
FILTERING VERSION (INTERNAL RE-CYCLING)
When there is no exhaust duct for venting out-door, you can use a
carbon filter (D). The air is depurate by the filter and put again in the
surrounding.
The air is released in the room through a connecting pipe, which
goes through the hanging cupboard and us connected to the
connecting ring supplied (A) Fig 1.
To use the appliance in this version, proceed as follows:
Open the grids (E)
To proceed to change the charcoal filter (D), the screw (B) has to be
removed.
Reinstall the grids.
Hood maintenance
Warning: always switch off the electricity supply before carrying out
maintenance work on the hood. In the event of a fault, contact an
official distributor or authorised dealer.
Cleaning the outside: use liquid, non-corrosive detergent and avoid
using abrasive cleaning products and solvents.
Do not use high-pressure or steam cleaning devices.
Grease filters (Fig. 5): to avoid fires, clean thoroughly once a month
or whenever the display pilot light indicates as such. To do so,
remove the filters and wash with hot water and detergent. If using a
dishwasher (metal parts may turn black without this affecting their
functional capacity), load the filters vertically to avoid solid residue
from being deposited.
Activated charcoal filters: replace the every 3 months.
Important: increase the filter cleaning/replacement frequency if the
hood is used for more than 2 hours a day. Always use genuine filters
from the manufacturer.
Bulb replacement (Fig.3)
Warning: do not handle the bulbs until the electricity supply has
been switched off and they have cooled.
Important: use new bulbs according to that indicated on the hood
nameplate.
If using LED lighting, do not look directly at the light.
Use bulbs with an aluminium reflector to replace halogen bulbs. Do
not use dichroic bulbs - risk of overheating.
For LED lamp replacements, please contact Technical Support or the
distributor of the brand.
In case of possible failure, before calling the technical service, check
the following table:
Problem
The lamps do not work
The motor works, but it seems to
have requested performance or
extraction capacity
The hood works, but the smell of
the food persists.
The hood does not work
The hood still does not work
9
Cause / Solution
A change may be necessary, but first check that
the lamp is correctly positioned and that the
contact is correct. Remember that lamps are not
covered by the warranty. Disconnect the current
hood before handling the lamps. Use lamps with
the same properties described on the nameplate.
It is advisable to use lamps supplied by the
manufacturer of the hood.
The selected speed is too low / Select a higher
speed
Check the Metallic Filter (grease filter). If it has
not been washed recently, it may be clogged
with grease or dirt. Disassemble and wash it
in hot water and detergent, and let it dry before
reassembling again.
Ensure that the air outlet tube has not been
obstructed.
If you are using the hood in recirculation mode, the
Active Carbon Filter must be replaced.
Check that the hood is connected to power.
Check that the fuses or automatic have not
jumped.
If, after having checked the points mentioned
above, your problem has not yet been solved,
contact the technical service or your distributor.