Storage And Care - MAKANI ARGUS Instrucciones De Uso

WARNING
• It is recommended to wear full, safety-tested protective equipment and personal protective equipment. Complete protective equipment includes:
helmet, gloves, knee-pads, elbow-pads)
• Ensure that your child has put on a helmet, knee pads and elbow pads before traveling.
• Also, the child should wear comfortable shoes with a rubber sole.
• Before use, carefully read the instructions for assembling a scooter.
• The scooter must only be assembled by an adult.
• Either the scooter assembly must be tested by an adult.
• Before use, you must instruct the child.
• It is forbidden to ride from the slopes and drive into the slope.
• The scooter brake is not designed to brake when rolling from a mountain.
• It is forbidden to travel on this model at a speed of more than 15 km / h.
• Children may use the scooter only under the supervision of an adult.
• Before use, check how tightly all bolts and nuts are tightened.
• Do not recommend for children under 8 years.
• This product complies with European standard EN 14619. The materials used for making this product are suitable and safe for children' s health.
• Safety always takes precedence over speed when riding a scooter. When driving downhill, be careful not to accelerate too fast so that you can always
jump off the scooter without falling. Jumping on a moving scooter is dangerous.
• Do not perform tricks on the scooter. This product is intended for use as a vehicle and for entertainment, but not for extreme sports.
• Only one person can use the scooter at a time.
• Do not allow the child to drive at night or in low light conditions. Do not allow your child to drive on the road or drive in crowded places due to the risk
of collisions with vehicles and pedestrians.
• Do not ride the scooter near a river, pool or other obstacles. Do not drive the scooter near glass windows and doors, a collision with a glass obstacle can
injure you and your child.
• The scooter meets the high quality standards. All materials are carefully selected and collected. Please note that we are not responsible for excessive
wear, damage to the product or injury caused by careless use and improper handling.
ASSEMBLING THE SCOOTER
You can fold or unfold the scooter without assistance. Be careful not to pinch your fingers. Make sure all eccentrics are securely tightened.
I. UNFOLDING THE SCOOTER
Before assembly, it is recommended to check the availability of all the components of the scooter. To do this, unpack the box, pull out all the
components and lay out on a flat smooth surface.
1. Loosen the bracket (Figure 1).
2. Pull the plastic handle to extend the bracket shaft (Figure 2).
3. Unfold the steering tube (Figure 3).
4. After the scooter is unfolded, the bracket shaft will return to the recess. Secure the bracket . If necessary, you can adjust the degree of its tension using
the nut (Figure 4).
5. Insert the handlebar grips until you hear a click (Figure 5).
6. Loosen the handlebar tube bracket and adjust the handlebar height. Secure the bracket . If necessary, you can adjust the degree of its tension using
the nut (Figure 6).
II. FOLDING THE SCOOTER
1. Loosen the bracket and fold the steering wheel (Figure 1).
2. Pull the grips out of the handlebar base (Figure 2).
3. Pull the plastic handle to extend the bracket shaft (Figure 3).
4. Fold down the steering tube. The front wheel must be between the two parts of the folding mechanism (Figure 4).
5. After folding the scooter, fasten the bracket (Figure 5).
STEERING HEIGHT
In order to set the required height of the steering wheel, you need to loosen the clamp of the steering rack of the scooter, pull the steering wheel up /
press it (if you need to lower it) and turn the clamp back.

STORAGE AND CARE

It is recommended to lubricate the bearings and fixings of the scooter.
It is recommended to store the scooter in a dry ventilated area.
ENGLISH