Midwest Cat Playpen 130 Instrucciones De Montaje página 4

Lift the Front Panel into the upright position. As you
8.
did in Step 5, make sure the bottom of the Front Panel
is rolled to the inside of the pen. The Front Panel has
four rounded hooks on each side. Lift and lower each
Side Panel into the hooks of the Front Panel as you did
in Step 4.
Hook the "S" clips on the base, on each side of
the pen, around the lowest horizontal wire of the
Side Panel for added stability.
Swing the Top Panel up and over the pen.
9.
Secure the Top Panel to the Front Panel first. Wrap each hook on the Top Panel around the top wire of the Front Panel. There is
10.
a bent "U" shaped wire in the middle of the Top Panel; this should go on the inside of the Front Panel.
Wrap the four hooks on the Top Panel around the top wire of the
Front Panel.
The bent "U" shaped wire should be secured on the inside of the
Front Panel.
4.