Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7. BATTERY INSTALLATION
Remove the battery cover from the remote control and put 1x3V Cr2015lithium
battery inside the compartment.
The following diagram shows the correct way to insert batteries.
8. ATTACHING THE BASE
1.
Carefully, take the Energy™ Docking 330 body and base out of the packaging
2.
Take the screws abd washers out.
3.
Attach the base to the body aligning the three holes in the base with three holes
in the Energy™ Docking 330.
4.
Screw the base into the body.
5.
Stand the Energy™ Docking 330 upright on the floor.
Your Energy™ Docking 330 is ready for use.
All manuals and user guides at all-guides.com
25
Publicidad
Tabla de contenido
