Safety Symbols; General Power Tool Safety Warnings - Dremel HSGP-01 Instrucciones De Funcionamiento Y Seguridad

1605A000E8.qxp_HSGP-01 6/25/20 11:13 AM Page 2
The definitions below describe the level of severity for each signal word. Please read the
below may result in electric shock, fire and/or serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
The term "power tool" or "tool" in the warnings or instruction text, refers to battery-
operated (cordless) glue pen.
temperature is 338° F (170° C). Do not
touch melted glue or nozzle area. If
accidental contact occurs, do not remove
glue. Immediately put burned area into cold
water. Always wear protective clothing,
safety glasses, gloves, long sleeve shirt and
long pants. Keep out of reach of children.
Keep away from flammables. No user
serviceable parts inside. Manufacturer
assumes no responsibility for consequential
or indirect damages from the use of this
product.
not use any
recommended glue sticks. Permanent
damage to the glue pen could result.
Do not use hot melt glue to replace
structural fasteners. The adhesive used with
this glue gun will begin to soften at 140° F
(60° C). Don't use the glue on objects that
will be subjected to temperatures of 140° F
(60° F) or above.
Avoid accidental discharge. Do not touch
glue stick or trigger except to dispense
glue. Feeding or pushing glue stick with too
much force into heated glue pen may cause
hot glue to be unexpectedly expelled from
nozzle or to flow back from inlet tube.

Safety Symbols

manual and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.

General Power Tool Safety Warnings

Read all safety warnings, instructions, illustrations and specifications
provided with this power tool. Failure to follow all instructions listed
Melted glue will burn
skin; operating nozzle
Do not attempt to melt
crayons or candles. Do
material other than
Do not pull glue sticks from glue pen. The
feed mechanism may become damaged or
impaired. If you desire to change types of
glue, cut off protruding end and feed the
remainder through with the new type of
glue.
Do not store the glue pen in direct sunlight
for extended periods.
Never attempt to force cool the glue pen
after use by immersing any part of it in
water or any other liquid. Allow the glue
pen to air cool only. Allow glue pen to cool
before storing.
This glue pen contains no user serviceable
parts.
Do not incinerate this glue pen even if it is
severely damaged.
This glue pen is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the glue pen
by a person responsible for their safety.
Children should be supervised to ensure
that they do not play with the glue pen.
-2-