Lanaform Family Care Manual De Instrucciones página 6

Ocultar thumbs Ver también para Family Care:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Fault
EN
Unit does not blow, no mist
Unit blows, but no mist
Mist has a strange smell
Low power
The mist does not rise
Noise
The mist issues from all around the
diffuser nozzle.
6
All manuals and user guides at all-guides.com
Possible causes
No power.
Main power switch off.
The water level is too high.
Leak from water reservoir
No water in the reservoir.
The water level detector is not in the
right position.
The temperature of the unit is too
low.
The water has been standing too
long in the reservoir.
The unit is new.
The mist power level is set to
minimum.
Deposits on the transducer.
The water is too cold.
The water is not clean.
The reservoir and the base unit are
not perfectly seated.
Resonance caused by the water level
in the reservoir being too low.
Resonance caused by an unstable
surface.
The fan unit is not functioning
correctly.
There is resonance with the table
There is a gap between the diffuser
nozzle and the water reservoir.
There is a gap between the diffuser
nozzle and the water reservoir.
Corrective action
The device is not plugged in correctly
or your power supply is defective
Switch on the main power switch.
Remove some water.
Close the lid correctly.
Fill the reservoir.
Position the water level detector
correctly.
Place the unit in a room at ambient
temperature for half an hour before
use.
Clean out the reservoir and add fresh
water.
Open the water reservoir and
ventilate for 12 hours in a cool room.
Adjust the control button to the
correct setting.
Clean the transducer.
Use water at a normal temperature.
Clean out the reservoir and add fresh
water.
Check for correct seating
Add water to the reservoir.
Place the unit on a stable surface.
Ask a specialist to check the fan in
the base unit.
Position the unit on a solid table or
on the floor.
The problem will disappear
automatically after prolonged use. If
not, plunge the diffuser nozzle into
the water before use.
The problem will disappear
automatically after prolonged use. If
not, plunge the diffuser nozzle into
the water before use.

Publicidad

Tabla de contenido
loading

Tabla de contenido