Solter LITHIUM LT-32 PRO Manual De Instrucciones página 8

All manuals and user guides at all-guides.com
LCD DISPLAY DESCRIPTION
1 - POWER DISPLAY
Press the "POWER" button. The display shows the charge level. The 100%, indicates that the battery is full. If the
display shows "BATTERY LOW RECHARGE", indicates that the battery is low, so you must charge the booster.
2- CHARGE
When the booster is charging, the displays show, "CHARGING" and the current battery power.
3 - USB OUTPUT DISPLAY
When the USB OUTPUT is connected and the power button is pressed, the display shows "USB1 USB2 ON". Then it
can be use to charge phones, tablets or other USB devices.
4 - OUTPUT REVERSED
When the starter is connected incorrectly to a battery, the display will show "WARNING CLAMPS REVERSED CHECK
ALL CONNECTIONS". At this time, the start is forbidden. Remove the jumper cables and connect again correctly (the
red clamp has to be plugged to the + and the black clamp to the negative).
5 - OUTPUT SHORT-CIRCUIT
If starter detects that the vehicle's battery is in short-circuit, the display will show "WARNING SHORT CIRCUIT CHECK
ALL CONNECTIONS". At this time, the start is forbidden and you must contact with the local distributor.
6 - 12V/24V OUTPUT DISPLAY
In case that the starter doesn't detect automatically the battery voltage (12/24V), you can select manually by pressing
the 12V or 24V button during 3s. In the display shows "12VJUMP START READY" or "24V JUMP START READY". An
incorrect selection could cause serious damage to the vehicle and / or the starter!
INSTRUCTIONS TO START A 12V/24V VEHICLE
1 – Push the power button and check that the starter battery charge is not less than 60%.
2 - Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BLACK clamp to the vehicle's
battery negative (-) terminal.
3 - The starter will check the battery voltage which is plugged in and will show the message "12V JUMP START
READY" or "24V JUMP START READY". If the starter does not recognize the battery voltage of the vehicle (12 / 24V)
automatically when is connected to this, manually select the voltage to be applied by pressing the 12V or 24V button
during 3s. An incorrect selection could cause serious damage to the vehicle and / or the starter!
4 - Start the vehicle.
5 - When the vehicle is started, disconnect RED clamp and the BLACK clamp from the vehicle's battery. Leave the
vehicle's engine running to charge the battery.
Do not attempt to start a vehicle for more than 5 seconds. After that time, disconnect the starter from the battery and try
again after 5 minutes.