Proper Usage - Brydge Vertical Dock Manual Del Usuario

ASSEMBLY
1. Remove base, chassis, screws &
screwdriver from packaging.
4. Tighten the two screws.
NOTE: To use external displays with the MacBook in the Vertical Dock, power must be connected, along with an
external keyboard/mouse.
INSERT & REMOVE
1. INSERT: Gently insert your
MacBook into the bottom
of the black sleeve.

PROPER USAGE

Dropping the MacBook into the Vertical Dock can damage the ports and dock connectors. Forcing or wobbling the
computer into or out of the dock could result in port damage. Make sure that your grip on the computer is secure
before docking and undocking.
Do not insert upside down or backwards, this may result in port damage or cosmetic damage to your MacBook. The
MacBook should only be docked with the left-side ports down and the monitor hinge to the rear of the dock.
Cosmetic wear to the surface finish may result from any device that plugs into the MacBook, including the Vertical
Dock. Minor wear around the MacBook's ports is considered normal.
2. Turn the chassis upside down.
5. Flip dock over with Thunderbolt
ports facing toward the back.
2. SEAT: Push down until the
Thunderbolt ports engage.
HAVE A QUESTION? Visit www.brydge.com/support
3. Place base so that it fits snugly to
chassis & screw holes are aligned.
(Base plate only fits correctly
in one orientation)
6. Connect devices to the
Thunderbolt 3 ports on the
back of the Vertical Dock as you
would with your MacBook ports.
3. REMOVE: Pull up and
remove your MacBook.