Hoses And Fittings - Greencut jet260x Manual De Instrucciones

The pump outlet pressure is set at the factory. It is not necessary to modify the outlet pressure setting valve unless
the pump includes a specific adjuster. Altering the outlet pressure may damage the machine and void the product
warranty.
SEALED
The pumps are constructed in such a way that they are maintenance-free. The pumps are already supplied with
production oil and do not require filling/inlet caps, oil changes, an oil sight glass or a filling system. The appearance
and characteristics of the pump are:
1. Pump inlet
2. Pump outlet
3. Detergent port
4. Pressure Relief Valve

HOSES AND FITTINGS

The machine comes with necessary hoses and fittings.
TURBO-HEAD ASSEMBLY
If the "turbo head" and turbo-head is not assembled, 1) wrap the threaded part of the turbo-head adaptor fitting
with plumbers Teflon tape (not supplied), then 2) screw the adaptor into the turbo-head, then 3) use an Allen key
through the adaptor to tighten it firmly to the turbo-head.
"QUICK-CONNECT" TYPE CONNECTORS
1. Ensure the connectors are clean.
2. Pull back on the knurled ring until the ball bearings are visible and hold it in this position, then insert the male
connector into the female. When the parts are fully connected, release the knurled ring.
2
1
3
3
2
73
4
1
EN