Trust START-LINE ASUN-650 Manual Del Usuario página 10

11. Code confirmation
The LED indicator of the receiver will blink fast to confirm
the code has been received. The receiver can store up to
32 different transmission codes in its memory. The memory
will be preserved when the receiver is moved to another
location or in case of power failure.
12. Install the receiver
Install the receiver in a standard junction box or other type
of housing (break off the mounting tabs if necessary).
Close the housing with a blind cover.
13. Manual operation with a Trust Smart Home
transmitter
1. Send an ON-signal to raise the screen.
2. Send an ON-signal again to stop.
3. Send an OFF-signal to lower the screen.
4. Send an OFF-signal again to stop.
Momentary switch only: every command (up/down/stop)
needs to be given twice.
14. Explanation COM-contact
The module contains 2 voltage-free contacts: [
In the neutral position, the contact [COM] is not switched.
After an on/off signal from a Trust Smart Home transmitter,
[COM] switches either to the [
2 minutes, the COM contact switches back to its neutral
position.
] and [
] or [ ] contact. After
ASUN-650 SUN BLINDS SWITCH
Single code delete
1. Press the learn-button for 1 second. The learn-mode
will be active for 12 seconds and the LED-indicator will
blink slowly.
2. While the learn-mode is active, send an OFF-signal to
delete the code of a specific Trust Smart Home transmitter.
3. The LED indicator will blink fast shortly to confirm
transmitter code deletion.
Full memory delete
1. Press and hold the learn-button on the receiver
(aprox. 6 sec.) untill the LED-indicator starts blinking fast.
The delete mode will be active for 12 seconds.
2. While the delete mode is active, press the learn button
on the receiver again for 1 second.
3. The LED indicator will blink fast shortly to confirm
memory deletion.
For information about the SET button please go to
www.trust.com/71017
].
EN
2