Charging Steps - Worx WA4009 Manual

CHARGING STEPS

Note: Please read the instructions
carefully before use.
WARNING:
Do not use other chargers to
charge the battery pack or use this
charger to charge other battery packs
and ordinary non-rechargeable
batteries. It is forbidden to contact any
metal object with the charger or the
electrode of the battery pack.
8
INSTALLATION AND
OPERATION
1. Insert charging stand into battery
pack
2. Remove the charging stand
First, press the battery pack button,
then drag the charging stand to slide
out.
Note: When not in use, the charging
stand should be removed from the
battery pack.
3. Charging button on charging stand
The charging stand has an on/off button
(1).
You need to press the charging button
to charge. The LED power indicator (2)
lights up for five seconds and then goes
out. During charging, press the charging
button to show the remaining power
of the battery pack on the Charging
USB Charger Adapter
indicator. The indicator light will go out
after 5 seconds.
4.Charging
The LED power indicator shows the
remaining power of the battery pack as
follows:
Press the button, the indicator shows
different status according to the battery
pack's power.
When the button is released, the indicator
light will be on for 5 seconds.
Status
Note: If the power is less than 10%, the
charging stand will stop discharging.
This means that the battery pack needs
to be charged.
5.USB charging port
The charging stand is equipped with two
USB charging ports (3)
Note: In order to prolong the service
life of the charging stand, please do
not insert a cell phone whose charging
current exceeds the current shown in
the label on the charging stand. When
Capacity
90%-100%
70%-90%
40%-70%
10%-40%
<10%.
EN