Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Alarm Clock Dock Buttons and Parts:
Fig. 1
1 2
3
4
9
10
11
1. timer
7. al set
2. time set
8. dock
3. audio
9. set +
4. power
10. set –
5. al1 al2
11. snooze/nap
6. al mode
12. vol +
14
Fig. 2
4
(iPhone not included)
8
6 7
5
12
13
13. vol –
14. AUX IN
Connector
Cable Jack
15. AC/DC Adaptor
15
Alarm Clock Dock Main Features:
• Simple docking to charge, play, and display your iPod/iPhone
• Alarm Clock Radio with FM digital tuner
• Easy-to-read large display with illuminated LCD
• Snooze/Nap bar for further relaxation
• Clear, Quality Sound (6 Watt x2 Output)
• Digital Volume (0~10 level)
• Full-Range Dual (2) Speakers Included (2" diameter)
• Remote Control for your convenience
• 3V DC (1 x CR2025)- for Remote Control (included)
• 3 'AA' batteries for emergency backup function of clock (not included)
• 12V / 1.5A (120V input) AC/DC Adaptor (included)
Remote Control battery installation:
Simply pull tab out to activate battery power. One Remote Control included. 3V
DC (1 x CR2025) included.
Installing or Replacing Backup Batteries:
This system uses 3 x AA backup batteries (not included) to provide backup alarm
operation and clock settings in the event of a power failure. After backup battery
installation, if a power failure does occur or if the AC cord does accidentally
disconnect, the display backlight will not remain lit, but current time and alarm time
settings will be temporarily maintained.
Otherwise, you must reset the time and alarm settings.
1. Open backup battery compartment door located on the bottom of the unit.
2. Please make sure the AC adaptor is connected. Otherwise all settings may be
lost during battery replacement.
3. Insert 3 (three) AA batteries, checking that the polarity ("+" and "–" ends of
the battery) matches the drawing near the battery compartment. Close the
compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).
5
Publicidad
Tabla de contenido
