User Maintenance Instructions; Care & Cleaning Instructions; Storing Instructions - Throwback 3 in1 Treat Baker Manual De Instrucciones

User Maintenance Instructions

This appliance requires little maintenance. It contains no user serviceable parts. Do not try to repair it
yourself. Contact a qualified appliance repair technician if the product requires servicing.
Care & Cleaning Instructions
CAUTION: Unplug from electrical outlet and allow to cool thoroughly before cleaning.
1. The Treat Maker body does not disassemble for cleaning.
2. Allow unit and baking plates to cool fully. Following the detailed instructions provided in
the "Before Using for the First Time" section of this instruction manual, remove baking plates.
WARNING: Use both hands to ensure that the upper baking plate does not fall onto
the Treat Maker during removal.
3. Never immerse appliance in water or other liquids. Never place the Treat Maker in dishwasher.
4. Brush baking plates with a clean, soft pastry brush or cloth.
5. To condition baking plates: Brush a generous coat of vegetable oil onto each of the lower and
upper baking plate cake cavities. Spread oil with an absorbent kitchen towel and wipe off any
excess oil. After a time, if baked treats show signs of sticking, recondition as needed.
6. Carefully follow suggested cleaning procedures below. To protect the premium quality
non-stick surfaces, use only plastic, nylon or wooden utensils.
7. To remove any batter baked onto the baking plates, pour a small amount of cooking oil onto
the hardened batter. Allow to set for 5 minutes, then wipe softened batter off with a paper
towel or soft cloth. Remove stubborn stains with a plastic mesh puff or pad. A clean round
kitchen brush or a toothbrush works well to remove baked-on batter from the cavities.
For best results, use only products with directions stating they are safe for cleaning non-stick
cooking surfaces. Do not use steel wool or coarse scouring pads.
8. The exterior finish should be cleaned with a non-abrasive cleaner and a soft, damp cloth.
Dry thoroughly.
9. Assemble clean upper and lower baking plates before storing. See "Before Using for
the First Time" section in this instruction manual for a complete description.

Storing Instructions

1. Make sure unit is unplugged and fully cooled.
2. Always store the Treat Maker with 2 matching upper and lower baking plates properly
assembled and locked into position.
3. Close the Treat Maker. Fold the handle latch over the handle to lock.
4. Use the cord wrap on the bottom of the Treat Maker. (See Figure 7.)
Figure 7
5. Do not put any stress on cord where it enters unit, as this could cause cord to fray and break.
6. Store Treat Baker in its box or stand unit on its end for easy and compact storage.
(See Figure 8.)
Figure 8
10