Eco-De ECO-2570 Manual página 23

Connect the plug to electricity, place the device security in place on the control panel (page 7,
photo 6 ) and press the power switch located on the lower rear of the machine. ( Behind the
base tape ) . The display will light and emit five beeps and display " === " . Press the power
button control panel .
When you press the button ON / OFF control panel ,the machine will not start running until 3
seconds displayed on the screen , thereby being able to prepare for use , after this tape 3
seconds starts moving and the machine goes into manual mode and the speed displayed on
the screen. The initial value of speed is 0.5 and 0.5 may be changing in 0.5 up to 6 km / h by
pressing the Speed + button, if want to slow down the speed button pressed - it will reducing
up to 0.5 at 0.5 speed desired , press these buttons to change the speed + or - as desired . To
see the other options function on the screen press the Mode button on the control panel is
It will change as press to see the speed, time, distance and calories , pressing the button and
go indicate the function to show on the display (speed, time, distance and calories). If the
indicator shows SCAN function , the display information (speed, time, distance and calories)
every 5 seconds without having to press any buttons.
Three . The treadmill has 3 automatic programs, P1 , P2 andP3 . Each program lasts 10-30
minutes.
• P1 : the speed changes gradually : 1-2-3-4-3-2-1 .
• P2 : the speed changes gradually : 1-2-3-4-5-4-3-2-1-2
• P3 : the speed changes gradually : 1-3-6-3-6-3-6
After selecting the program you want to use , press the MODE button and select the time
Use 10-30 minutes by pressing + or - and press ON / OFF to begin use.
4 . When the tape is running by pressing the button ON / OFF control panel will cause the
5 . Safety device: Place the device security attached to any article of clothing worn .
By the time your body is separated from the panel Control for any reason , the device
security will take off and be released , the display "SAFE" and the machine will stop working
preventing further Moving and can cause a fall. To put in start the machine again when you 're
ready again to start walking, press the on the control panel will begin its normal operation
explained above .
6. The maximum operating time of the machine is 30 minutes, after which time it will cease to
operate , you can reset operation again by pressing the button on the control panel. For the
time Use press mode until the display shows function of time.