Tabla de contenido
Publicidad
All manuals and user guides at all-guides.com
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to connect
them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel and
adjust "Recording Volume".
Analog Surround
Audio Header
(17-pin HD_AUDIO2)
(see p.1, No. 28)
3W Audio AMP Output
Wafer Header
(4-pin SPEAKER1)
(see p.1, No. 27)
SPDIF Out Connector
(2-pin HDMI_SPDIF1)
(see p.1, No. 26)
18
17
PIN
18
16
14
12
10
8
2
1
6
4
2
Please connect the chassis
1
speaker to this header.
Front_R-
Front_R+
Front_L+
Front_L-
Please connect the SPDIF
1
Out connector of a HDMI
GND
VGA card to this header
SPDIFOUT
with a cable.
H110TM-ITX
Signal
Signal
PIN
Name
Name
SENSE
17
KEY
15
LFE
A_GND
A_GND
13
Center
Surr_Rear_R
11
A_GND
9
A_GND
Surr_Rear_L
Surr_Side_R
7
A_GND
A_GND
5
Surr_Side_L
Front_R
3
A_GND
A_GND
1
Front_L
19
Publicidad
Tabla de contenido
