T.I.P. STEAM 35000 INV Traducción De Las Instrucciones De Uso Originales página 26

Code Description
A08 The openness of the expansion valve
A09 Reserved
A10 Compressor current (A)
A11 PCB temperature (°C)
A12 Fan motor current (A)
A13 Real frequency of the compressor (Hz)
A14 Motherboard current (A)
A15 Fan motor speed (RPS)
Querying of system parameters:
This procedure is to assist with maintenance and future repairs.
The default settings should only be changed by an experienced professional.
Any change to the reserved settings automatically voids the warranty.
Parameter table:
Code
P01 Calibration of the temperature difference before restarting
P02 Reserved
P03 Reserved
P04 Setting the cooling temperature
P05 Setting the heating temperature
P06 Protection against excessive discharge temperature
P07 Discharge temperature too high reset temperature
P08 Compressor current protection
P09 Setting the compensation coefficient of the temperature water inlet
P10 Reserved
P11 Auto-activation time before de-icing starts
P12 De-icing activation temperature
P13 Maximum de-icing time
P14 De-icing deactivation temperature
Temperature difference between ambient temperature and coil temperature
P15
during defrosting
P16 Ambient temperature defrost
P17 Extended valve action time
P18 Target superheat temperature during heating
P19 Set the EXV discharge temperature
P20 The openness of EXV
P21 The mini opening for the electric expansion valve
P22 EXV mode of operation
P23 EXV year level
P24 Target superheat temperature during cooling
P25 Water pump switch-off time after reaching the set temperature
P26 Operating time of the water pump after reaching the set temperature
P27 EXV mode of operation during cooling
P28 Filtration pump servo control mode
24
Description
9
Factory setting
1 °C
27 °C
27 °C
120 °C
95 °C
Reserved
0 °C
45 min
-3 °C
8 min
20 °C
2 °C
17 °C
45 s
1 °C
95 °C
300
80
1 = auto
350
3 °C
45 min
5 min
1 = superheat temp.
1 = ON