Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Wireless Mode
1. Remove the sticker between battery and mouse before using.
2. Switch on M8600.
3. Connect the Charging Dock to your computer with the mini-USB cable.
4. Press the connecting buttons on M8600 and Charging Dock at the same time. When
the pairing process is completed, your M8600 is then ready for use in wireless mode.
5. To charge M8600 in wireless mode, just place it on the Charging Dock. There is also
at least 8 hours.)
6. To replace the battery with the spare battery, push the battery switch to the left as
shown. The battery will pop out instantly.
Wired Mode
1. Connect the mini-USB end of the cable to M8600.
2. Plug mouse into the USB port of your computer. M8600 is then ready for use as a
wired mouse. Besides, its battery will start charging automatically in this wired mode.
3. To remove the cable, push the cable switch to the right as shown before pulling out
the mini-USB connector.
3
Publicidad
Tabla de contenido
