Safety - Heylo KT 20 Serie Manual De Instrucciones

Type plate
Entfeuchter
KT XX
230 V ~ 50 Hz
Art.-Nr.: 11105XX
S.Nr.:
Stromaufnahme 4,2 A
Schutzart IP 44
Anschlußwert 0, 3 KW 9
The type plate is attached to the de-
vice.
Intended use
The device is intended solely for
dehumidifying air at atmospheric
pressure in a commercial environ-
ment.
Intended use also includes compli-
ance with the operating conditions
(see Operating conditions).
Any use other than the specified is
deemed improper. Improper use shall
void all warranty cover.
The air dehumidifier must not be
operated by children or by persons
with limited physical, sensory or men-
tal faculties.
Before operating the device, users
must have read and understood this
operating manual.
Reasonably foreseeable misuse
The device must not be used:
■
In rooms/spaces that are not
enclosed, or outdoors
■
In rooms with a potentially explo-
sive or aggressive atmosphere
20
HEYLO GmbH
Im Finigen 9
D-28832 Achim
www.heylo.de
Tel.: +49 (0) 42 02 – 97 55 0
Fax: +49 (0) 42 02 – 97 55 97
R290
Kältemittel
1 0g 5
Füllmenge
Entfeuchtungsleistung 45 l
(bei 30°C / 80% r.F)
■
In rooms with air that has been
treated with ozone, or that con-
tains a high concentration or sol-
vents or dust.
■
At locations where the prescribed
minimum safety distances cannot
be maintained

6 Safety

General safety instructions
■
The device must only be operat-
ed by persons who have been
properly instructed in its opera-
tion.
■
It is forbidden to make any modi-
fications to device.
■
Maintenance and troubleshooting
tasks must be performed by suit-
ably qualified persons only. Shut
down the device and disconnect
the mains plug.
WARNING! Risk of explosion, inju-
ry from burns or poisoning by
refrigerant
The device is operated with an odour-
less and flammable refrigerant. If the
device is operated incorrectly, there is
a risk that the refrigeration causes
explosion, fire, poisoning or other
injury. The refrigerant is pressurised.
 Only operate the device in rooms
2
larger than 4 m .
 Never drill holes into the device,
and do not use welding equipment
or cutting torches in its vicinity.
 Do not attempt to speed up de-
frosting by using implements.
 All work on the refrigeration circuit
must be performed by staff of the