Fuel Filling - Planika Senso Manual De Montaje

1. If the tank is empty (
( ). ATTENTION! Do not refuel when the flame is ignited!
2. If the fuel bottle is secured with the flame restrictor (cap on the bottles' neck) (II) please remove it before inserting
the fuel pump inlet (III) Place the fuel container stably on the floor and insert the pump hose 'c' (III). Press and hold
the button on the pump to start refuelling (IV).
Once the fuel container has been emptied, replace it with a full one and start the pump again (see point 2).
The pump will stop when the tank is full (sound +
3. Disconnect the power cable 'b'. To disconnect the pump, hold the end of the hose and firmly press the button in the
place marked with a sticker 'a' (V).
4. Shake the remaining fuel from the hose 'c' to the container and place the pump in the bag (VI).
The green diode indicates that the device is ready to ignite the flame.
Press and hold START for 3 seconds. Flame ignition will take 2-10 minutes (
can be present during the ignition. The diode READY off (
and the device reached the working temperature

FUEL FILLING

) or you want to fill the fuel, firmly connect the pump hose 'a' (click!) and power cable 'b' (I)
FLAME IGNITION
).
) indicates that
15
). The smell of ethanol vapours
the flame has been ignited