Velleman Group nv
Contact details
Legen Heirweg, 33 9890 Gavere, Belgium
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
6.
Operation
1. Install the appliance on a firm and level surface, free from obstructions and at least 1 m
away from any wall or combustible materials.
2. Make sure the selector knob is in the off position (0). Insert the power plug into the mains.
3. Turn the selector knob to either low (600 W) or high mode (1200 W), with or without
oscillation.
4. After use, turn the selector knob back to the off position (0) and disconnect the appliance
from the mains.
Note
This heater is equipped with a safety tilt switch, which automatically switches off the appliance
if it is not in the upright position.
V. 04 – 07/04/2022
selector knob
PHT2000
Other control options (multiple selections possible)
room temperature control, with presence
detection
room temperature control, with open window
detection
with distance control option
with adaptive start control
with working time limitation
with black bulb sensor
6
no
no
no
no
yes
no
©Velleman Group nv