Care And Cleaning - Therabody TheraFace PRO Manual De Instrucciones

EN
Warnings: Use only as directed. Avoid eye contact. Do NOT use the on the midline
of the neck. Prior to starting the microcurrent treatment, test by applying a small
amount of the TheraOne Conductive Gel on a small patch of skin first. Skin may
absorb gel during microcurrent session; reapply if needed to ensure even glide of
device on the skin.
If you already use a toner, serum, moisturizer, and/or SPF, then apply in
this order following the completion of any TheraFace PRO protocol:
1. Tone: Use one cotton pad with toner applied sweeping gently
across the face, avoiding the eye area and concentrating on the
nose, nasal fold, and chin
2. Serum: Apply serum
3. Moisturizer: Apply moisturizer
4. SPF: Apply SPF only in the morning or daytime hours
9
TheraFace PRO Device After Care & Cleaning
After Skin Treatment
Clean your face with a warm, damp washcloth.
Device Maintenance
The following maintenance instructions are important to ensure that
your device continues to work as it was designed. Failure to follow these
instructions may cause your device to stop working.

Care and Cleaning

Visually inspect the TheraFace PRO device and attachment rings for any obvious
signs of debris build-up. Wipe your device and attachment rings down with a damp
cloth or alcohol-free cleansing wipe. After cleaning, allow the device and attachment
rings to dry thoroughly before storing or beginning another treatment protocol. A
properly cleaned device should have no visible signs of debris or moisture.
Note: This product is not waterproof, only clean with a damp cloth or alcohol-free cleansing
wipe by wiping the device and attachment rings. Do not submerge the device in water or clean
it under running water (other than the Cleaning Ring). Do not allow the device to come into
contact with any corrosive solutions, which would damage appearance and function. Store
the device in a cool and dry place (Temperature: 0°C/32°F - 40°C/104°F Relative humidity:
10~95% RH). Do not store the device or battery where temperatures may exceed 40°C/104°F,
such as in direct sunlight or in a vehicle.