AmazonBasics B088XT53Z9 Guia De Inicio Rapido

B088XT53Z9
Toilet Paper Holder - Contemporary, Includes Storage Shelf, Stainless Steel
Porte-Papier Hygiénique - Contemporain, Comprenant une Tablette de Rangement, Acier Inoxydable
Toilettenpapierhalter - Modern, Inklusive Ablagefach, Edelstahl
Portarotolo Carta Igienica - Contemporaneo, con Ripiano Ripostiglio, Acciaio Inox
Portarrollos para Papel Higiénico - Contemporáneo, Incluye Estante, Acero Inoxidable
WC-Papierhouder - Eigentijds, Inclusief Legplank, RVS
トイレットペーパーホルダー - コンテンポラリー、収納棚付き、ステンレス
This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.
CAUTION
• Make sure these instructions are read and completely understood before attempting installation.
If you are unsure of any part of this installation, please contact a professional installer for assistance.
1
2
3
4
1/4" (6.35 mm)
Step 1: Mark Location
Remove protective covering. Choose installation location. Position flat side of toilet paper holder against wall and mark
both hole locations with a pencil. Holes should be level and horizontal to each other.
Optional: Use level to ensure pencil marks are level to each other. Adjust marks up or down as needed until level.
NOTICE
Step 2: Trepanning
Using a drill and 1/4" (6.35 mm) drill bit, drill a hole on each of the pencil marks. Ensure to only drill through
the thickness of the drywall.
NOTICE
Step 3: Insert Drywall Anchors
Step 3: Insert one drywall anchor into each of the drilled holes. Tap anchors lightly with a hammer until flush with wall.
NOTICE
Step 4: Install Screws
Slide a washer to each screw. Ensure flat side of washer is facing toilet paper holder and recessed side is facing
screw head. With flat side of toilet paper holder against wall, position holes overtop drywall anchor(s) and/or pilot
hole. Install and tighten screws using philips head screwdriver. Ensure fixture is secured to wall by gently moving
side to side.
If one of the holes will align on a stud, follow stud installation notes in step 2. To check to see if one
of the holes will align with a stud locate stud using a stud finder.
For wall stud installation on one of the holes, use drill and 1/8" (3.175 mm) drill bit to drill pilot hole.
If installing into wall stud, do not use drywall anchor for 1/8" (3.175 mm) pilot holes.
A (1x) B (2x) C (2x) D (2x) E (2x)
01