Rear Panel - Montarbo TP-11 Manual De Uso

TP-11
7 INPUT LEVEL
This button acts as a pre-fader listening (PFL) control. When pressed, it enables you to
check the input level on the OUT/IN VU meter and optimise the gain accordingly.
8 LEVELS
LED indicators for IN/OUT and Gain Reduction levels:
- OUT/IN: in the most common situations of use, shows the level of the output signal.
When the INPUT LEVEL button is pressed, shows the level of the input signal.
- GAIN REDUCTION: displays the output gain reduction from the top to the bottom.
9 LOW CUT
This switch activates (On position) or deactivates (Off position) the high pass filter.
10 POLARITY
Operate this switch to reverse the phase of the signal (180°).
16

REAR PANEL

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
TUBE PREAMP
this device must accept any interference received,
including interference that may cause undesired operation.
"CAUTION"
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
"ATTENTION"
RISQUE DE CHOCH ELECTRIQUE
NE PAS OUVRIR
DC 12V/2A
15
POWER
14 13
11 OUTPUT BAL
Connect this balanced output to a recorder, sound card or mixer via a balanced XLR
cable.
12 OUTPUT UNBAL
Connect this unbalanced output to an amplifier or external processor via an unbalanced
jack cable.
13 DIRECT OUT
Direct output for the signal not processed by the preamp.
User manual
AEB INDUSTRIALE S.R.L.
Via Brodolini, 8 - Località Crespellano
40053 VALSAMOGGIA (BO) - ITALY
www.montarbo.com
BAL. UNBAL. BAL.
12
11
17