Charging Instructions - Oxford Journey Manual De Instrucciones Y Garantía Para El Usuario

E n g l i s h

8. Charging Instructions

The batteries are located in the power pack and are charged via an off board desktop charger unit.
Hand Control
Boom Raise
Lower Buttons
Battery Charge
Level Indicator
When the power pack needs charging, it can be removed from the lift and fitted to an off board
charging unit. The battery charge level is displayed by the indicator on the control box.
Joerns Healthcare recommends an additional battery pack is purchased, so that one pack can
be on charge at all times
1. Remove the power pack from the lift. A simple latch at the top of the power pack retains the
pack. Lift the latch and the power pack will be released.
2. Fit the power pack to the charging unit. The location and latching of the power pack to the
charger is the same system as used on the lift.
3. Plug the charger mains plug into a suitable mains outlet and switch the mains supply ON. (If
applicable).
4. Charging is automatic and will fully charge the batteries over a period of eight to twelve hours.
Note: Even if the charger is left plugged in for extended periods it will not allow the batteries to
overcharge.
5. To return the lift to service, switch OFF (if applicable) the mains supply and remove the power
pack from the charger. Fit the power pack to the lift and make sure the latch holding the pack
in place is fully engaged. "Click" in place. The charging of Oxford electric lifts is simple and
straightforward, but it is important to follow the charging instructions closely. Please pay particular
attention to the following points; they will help you avoid problems with discharged batteries.
The battery, charger, hand control & control box are NOT to be opened by unauthorized personnel.
(Contact your distributor for warranty and repairs).
DO NOT touch battery/charger terminals.
Removable
Battery Pack
Control Box
Emergency Stop Button
Boom Raise/
Lower Buttons
WARNING
WARNING
®
Oxford
Journey
19
294000.10050 Rev. B