Optional Accessories - Makita PV001G Manual De Instrucciones

Polishing basics
CAUTION:
Always wear safety glasses or a
face shield during operation.
NOTICE:
It is recommended that you have a trial
run over an inconspicuous spot to find an appro-
priate workload.
► Fig.19
1. Make sure that the workpiece is properly sup-
ported and both hands are free to control the tool.
2.
Hold the tool firmly with one hand on the switch
handle and the other hand on the loop handle, side grip
or tool head.
3. Turn the tool on, letting the polishing wheel reach
full speed. Then carefully enter into operation moving
the tool back and forth with steady pressure over the
workpiece surface.
NOTE: Keep the wool pad/bonnet at an angle of
about 15 degrees to the workpiece surface.
NOTE: Apply an even amount of gentle pressure over
the polishing wheel. Excessive pressure will result in
poor performance and premature wear to wool pad/
bonnet.
4. Having finished, switch the tool off and wait until
the wheel has come to a complete stop before putting
the tool down.
Polishing operations
Surface treatment
Use a wool pad for rough finishing, then use a sponge
pad (optional accessory) for fine finishing.
► Fig.20
Applying wax
Apply wax to the sponge pad (optional accessory) or
work surface. Run the tool at low speed to smooth out
wax.
► Fig.21
CAUTION:
Do not apply excessive wax or
polishing agent. It will generate more dust and may
cause eye or respiratory diseases.
NOTE: First, perform a test waxing on an inconspic-
uous portion of the work surface. Make sure that the
tool will not scratch the surface, or it may result in
uneven waxing.
Removing wax
Apply with a clean sponge pad (optional accessory).
Run the tool to remove wax.
► Fig.22
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning dust covers
► Fig.23: 1. Dust cover
Regularly clean the dust covers on the inhalation vents
for smooth air circulation. Remove the dust covers and
clean the mesh.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Lock nut 48
• Lock nut wrench 28
• Sponge pad (Hook & loop)
• Wool pad 180 (Hook & loop)
• Wool bonnet 180
• Backing pad 165 (Hook & loop)
• Rubber pad 170
• Sleeve 18
• Side grip (auxiliary handle)
• Loop handle
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
13 ENGLISH