FONESTAR SM-3512U Manual De Instrucciones página 3

16.- REC: line level recording output from the MAIN MIX output.
17.- TAPE: unbalanced line level input for directly allocating to the MAIN MIX output or CONTROL ROOM.
To see the level of the TAPE input in the LED STEREO LEVEL DISPLAY indicator, move the MAIN/PFL
button to the MAIN position and choose the CD/TAPE source on the SOURCE selector.
18.- AUX SENDS 1: signal output for the mix from the channels allocated to the AUX pre-fader auxiliary
sender, 6.3 mm mono jack connector.
19.- AUX SENDS EFX 2: signal output for the mix from the channels allocated to the EFX post-fader aux
sender, 6.3 mm mono jack connector.
20.- MP3 MUTE/MP3 TO CH11/12: button for muting the USB/SD/MP3 player output or sending it to the
11/12 stereo channel.
21.- SD: SD memory card connection slot.
22.- USB: USB port for USB memory connection.
23.- USB/SD/MP3 player controls:
PLAY/PAUSE: for starting or pausing playback.
STOP: stops the current playback. A long press on this button
allows you to change folders, then press the 7/8 buttons to
select another folder.
REPEAT: changes the repeat mode of the tracks.
7/8: skips to the beginning of the previous/next track currently
playing. If you keep the button pressed, you can decrease/increase the volume of the player.
USB/SD: allows selection between the USB storage device and the SD memory card.
24.- Display for the selected effect.
25.- EFFECTS: control knob for selecting the effect. To use the internal
effects processor, adjust the EFX control of the channel that you wish to
send to the processor and the intensity of the effect with the STEREO
AUX RETURNS 2 (EFX) control. The signal can be sent from the effects
bus to the MAIN or ALT 3/4 output using the MAIN/ALT 3-4 control.
14.- LINE 9/10, 11/12: balanced line level inputs with the possibility
of connecting mono or stereo inputs, 2 x 6.3 mm (balanced)
stereo jack connectors. If you wish to use channel as a mono
channel, only use channel L.
15.- STEREO AUX RETURNS 1/2: aux inputs generally used for
connecting the return from the audio signals sent to an
external processor using the AUX SENDS 1 and 2 (EFX)
outputs. They allow stereo or mono input connection, using
only the left input channel. 2 x 6.3 mm stereo jack connector.
NOTE: if you wish to use the internal effects processor,
nothing should be connected to the AUX RETURN 2, so as not
to cancel the internal processor.
- 3 -
EN