Troubleshooting; Corrective Action; Warranty - Kobalt KCS 1040B-03 Manual De Instrucciones

TROUBLESHOOTING

WARNING
• Turn the switch to the "OFF" position and remove the battery before performing
troubleshooting procedures.
PROBLEM
Tool does not work.
Motor runs, but chain
does not rotate.
Motor runs, chain
rotates but does not
cut.
Chain brake does not
engage.

WARRANTY

For 5 years from the date of purchase, this product is warranted for the original purchaser to
be free from defects in material and workmanship. This guarantee does not cover damage
due to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or
expendable parts and accessories expected to become unusable after a reasonable period of
use. This warranty is limited to 90 days for commercial and rental use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specific legal rights, and you may also have other rights
that vary from state to state.
POSSIBLE CAUSE
1. Low battery capacity.
2. Chain brake is engaged.
3. Battery overheating.
1. Chain does not engage
drive sprocket.
2. Chain tension too tight.
1. Dull chain.
2. Chain is on backwards.
Debris preventing full
movement of the chain
kickback brake paddle
Lowe's Home Centers LLC. Mooresville, NC 28117

CORRECTIVE ACTION

1. Charge the battery pack.
2. Pull the chain kickback brake
paddle backward toward the front
handle.
3. Wait for the battery to cool down, at
which point the tool can be started
again.
1. Reinstall the chain, making sure
that the drive links on the chain are
fully seated on the sprocket.
2. Re-tension the chain. Refer to
the "Adjusting the Chain Tension"
chapter in this manual.
1. Replace or sharpen the chain.
2. Reinstall the chain to reverse the
direction of the chain.
Clean debris from external chain
brake mechanism.
29
Printed in China