LEGRAND 430 608 Manual Del Usuario página 7

Installation procedures
Please follow the next installation steps:
(1) Please switch off cameras and monitors before installation;
(2) Connect the transmitter to the cameras via BNC-M and DC jack;
(3) Connect the transmitter to the receiver via UTP cable;
(4) Connect DVR / Monitors to the receiver via coaxial cables;
(5) Check all connections, and power on the receiver;
(6) Check if the image is correct.
Caution
430 608, 430 609 and 430 628 are not waterproof.
Do not operate the devices with wet hands.
If one end is EIA/TIA568A,the other end should also be EIA/TIA568A.
If one end is EIA/TIA568B,the other end should also be EIA/TIA568B.
Trouble shooting
In case of trouble, please follow these steps:
- Check if all connection is right, and if RJ45 in accordance with IA/TIA568A or 568B (see below)
- Make sure the real distance not exceeds the allowed transmission distance;
- If yellow LED on RJ45 is lighting on individual channel, please cut off the power supply and unplug the cable to check if there
is any short circuit or power consumption overload.
Panels diagrams
- Ref. : 430 608 (Récepteur 4 caméras et alimentation)
100-240V~ /50-60Hz
2
- Ref. : 430 609 (Récepteur 8 caméras et alimentation)
VIDEO & POWER RJ45 INPUTS
100-240V~ /50-60Hz
1 2 3
2
4 Ports Video&PowerSever
ON
NO.
OFF
POWER
1
1
2
4
3
4
VIDEO & POWER RJ45 INPUTS
1 2 3 4
VIDEO OUTPUTS
3
8 Ports video&Power Server
ON
OFF
NO.
POWER
1
1
2
4
3
4
4 5 6 7 8
VIDEO OUTPUTS
3
Component
Power LED Indicate if power supply is correct.
Power Supply Input 110 - 230V~ 50-60Hz power input connector.
BNC-F Video output.
RJ45 Green LED = power indicator (must be on).
Yellow LED = over-current indicator (must be off).
Component
Power LED Indicate if power supply is correct.
Power Supply Input 110 - 230V~ 50-60Hz power input connector.
BNC-F Video output.
RJ45 Green LED = power indicator (must be on).
Yellow LED = over-current indicator (must be off).
Description
Description