Mx Onda MX-HD2410 Manual De Instrucciones página 22

2. Using the adapter cable (Micro USB - USB) included,
connect the dental water jet to a USB port on your
computer (which must be on) or use a power adapter
with USB output whose voltage is 5 V and is capable of
providing 1.5 A (in the case of supplying less current
the battery will be slower).
3. During charging, the indicator 7 turn red and when
finished charging the battery, the indicator 7 turn blue.
4. Charging is complete, remove the Micro USB
connector and replace the cap that protects the
connector 8.
When the battery needs to be recharged?
When you observe pressure decreases drastically or the
dental water jet is turned off before two minutes, it will be
a sign that the battery is discharged and needs to be
recharged as soon as possible.
USE OF DENTAL WATER JET
Filling the water tank
1. With the dental water jet in off mode open the cover 1
of water tank 3.
2. Fill the tank without exceeding the maximum capacity
(which is the transparent tank), you can use weather-
water, hot water (without the temperature thereof
exceeds 40 °C) or mixed with some kind of mouthwash
or mouthrinse liquid.
3. Close the cover 1 of the water tank 3.
Inserting and removing the nozzle
To insert or remove the nozzle, the dental water jet must
be in off mode.
To insert the nozzle, insert it into the hole on the dental
water jet by the thickest part of the nozzle and then press
it firmly until you hear a "click" indicating that the nozzle is
properly retained.
To remove the nozzle press the release button 2 and pull
the nozzle.
6