Before Using The Electric Grill; Using The Electric Grill - Wilfa CG-2000B Manual De Instrucciones

BEFORE USING THE ELECTRIC GRILL

EN
Before using your electric grill for the first time, please follow the instructions
below:
1. Remove any stickers from the product.
2. Clean and condition the non-stick surfaces:
– Remove the two cooking plates by pushing the respective release buttons
and wash them thoroughly with hot, soapy water. Rinse and dry them well
and then place them back on the unit ensuring they lock into place.
– Do not immerse unit in water.
– To condition the cooking surfaces, plug the appliance into the appropriate
electrical outlet. The red power on indicator light will illuminate. Allow the
unit to pre-heat until the green ready to cook indicator light is lit up.
– Wipe a small amount of butter or margarine onto the cooking surfaces,
spread slightly and wipe away any excess.
Note: When using the unit for the first time, you may notice a fine smoke
haze coming out from the unit. This is normal. It is due to the initial heating of
internal components. The unit is now ready to use and it will not be necessary to
condition it again.

USING THE ELECTRIC GRILL

1. Plug the power cord into the appropriate electrical outlet. The power on
indicator light will illuminate and remain lit for as long the appliance is
plugged in.
2. Pre-heat the unit until the green ready to cook indicator light is lit.
3. Place the foods to be prepared on your grill on top of the non-stick cooking
surface(s). Use it closed if you would like to press the foods to be grilled or
open it at 180° angle, simply press and hold down the button and pull back
the handle and top grill to a completely open position (see figure 1).
INSTRUCTION MANUAL · MINIGRILL
8